| |
Hardened gear reducer as a screw lift and other transmission products necessary components, the stability of the entire transmission system plays an important role. However, if purchased in the purchase process to achieve the required hardness of the hardened surface reducer, or use the cycle is too long, or overload conditions, it will accelerate the hardened surface gear wear, thus affecting the normal transmission system run.
A: long after the failure of the main performance:
The use of vibration-enhanced, noise increases. The main reason for this phenomenon is: the chassis parts wear is too large or damaged.
2: possible damage to the parts: gear tooth wear, gear teeth broken, gear shaft hole or keyway wear; hole in the bearing hole because of wear and tear is easy to fail; axis, the keyway is also easy to use for too long Resulting in wear.
3: Repair: This repair method is not all maintenance department has the technical strength in accordance with this method for maintenance, but the case of large equipment, to find the repair point on the parts to repair, the overall cost of the enterprise will be significant savings.
01: If it is because of hard tooth surface reducer shaft shaft hole keyway wear, etc., can be taken to restore the original plating parts of the original accuracy.
02: If the hard tooth surface reducer gear teeth broken and other damage, only to re-processing of new parts. In order to ensure the use of hardened gear reducer, friends in the purchase of hardened gear reducer must be selected type, to ensure that the hard tooth surface reducer safety factor, and strictly follow the instructions to play hardened gear reducer Of the maximum efficacy. |
|
